Left running head:
Chapter name (automatic)
Open Shortest Path First
IP OSPF COST
ip ospf cost <1-65535>
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command
explicitly specifies the cost of sending a packet on an OSPF interface.
Note:
The value set by the 'ip ospf cost' command overrides the cost resulting from the auto-
cost command.
P
ARAMETERS
Parameter
1-65535
D
V
EFAULT
ALUE
The default cost is calculated based on the interface bandwidth.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf cost 100
IP OSPF DATABASE
ip ospf database-filter all out
D
ESCRIPTION
Enter this command in Interface Configuration mode. Enables filtering of outgoing
LSAs on OSPF interface.
P
ARAMETERS
None.
D
V
EFAULT
ALUE
By default, database-filtering is not enabled. All outgoing LSAs are flooded to the
interface.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf database-filter
all out
468
Beta
Unsigned integer value expressed as the link-state metric.
-
FILTER ALL OUT
Alcatel-Lucent
Description
OmniAccess 700 CLI Command Reference Guide
Beta