Show Interface Serial - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

SHOW INTERFACE SERIAL

show interface serial <slot/port>
D
ESCRIPTION
This command displays the configured value of fragment size and slippage MRU
configured on the specified interface.
P
ARAMETERS
slot/port
P S
LATFORMS UPPORTED
OmniAccess 740, 780
E
XAMPLE
ALU(config)# show interface Serial0/0:0
Serial1/0:0 is up, line protocol is up
Internet address is 3.3.3.2/24
MTU 1500 bytes, BW 1536 Kbit, DLY 0 usec,
Fragment-size 80, slippage mru 16
reliability 255/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation frame-relay,
LMI enq sent
LMI enq recvd 0, LMI stat sent
LMI DLCI 0 LMI type is Autosense
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/max) 0 drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 1536 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:1-24 (64Kbps each), Transmitter delay is 0 flags
R H
ELEASE ISTORY
Release 2.3: command was modified.
OmniAccess 700 CLI Command Reference Guide
Beta
Parameter
keepalive not set
0, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down
0, LMI upd sent
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Slot and port number of the interface.
0
frame relay DTE
show interface serial
315
Beta