Encapsulation Hdlc; Hdlc Keepalive - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
High-level Data Link Control

ENCAPSULATION HDLC

encapsulation hdlc
D
ESCRIPTION
This command is entered in the Interface Configuration mode. This command is
used to configure encapsulation on an interface to HDLC.
P
ARAMETERS
None.
D V
EFAULT ALUE
HDLC is the default encapsulation on an interface.
E
XAMPLE
ALU(config-if Serial0/0:0)# encapsulation hdlc

HDLC KEEPALIVE

hdlc keepalive <0-32767>
D
ESCRIPTION
Enter this command in the Interface Configuration mode.
This command configures the HDLC keepalive interval. The same value shall be
configured on the peer. A value of '0' turns off the keepalive feature.
P
ARAMETERS
0-32767
D V
EFAULT ALUE
Default is 10 seconds.
E
XAMPLE
ALU(config-if Serial0/0:0)# hdlc keepalive 12
244
Beta
Parameter
Alcatel-Lucent
Description
HDLC keepalive interval in the range of 0
- 32767 seconds.
OmniAccess 700 CLI Command Reference Guide
Beta