Linecode - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

LINECODE

linecode {ami|b8zs}
D
ESCRIPTION
This command is used in the Controller Configuration mode. Use this command to
configure the line-code type for a T1 line. The T1 service provider determines
which line-code type, ami or b8zs, is required for your T1 circuit.
P
ARAMETERS
Parameter
ami
b8zs
D V
EFAULT ALUE
The default linecode value is b8zs.
E
XAMPLE
The following example specifies AMI as the linecode type for a T1 line:
ALU(config-controller T1)# linecode ami
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Alternate Mark Inversion (AMI) line-code type.
Note: If 'ami' linecode is configured, configure
timeslot speed to 56Kbps to ensure 1st
density.
b8zs line-code type.
Alcatel-Lucent
linecode
229
Beta