Source-Nat Static - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Network Address Translation
-
SOURCE NAT STATIC
[<1-65535>] match [{all|any}] <match-list name> source-nat
static
D
ESCRIPTION
Enter this command in the NAT configuration mode. This command is used to
configure a static SNAT that uses one-to-one address mapping without port
translation.
Note: If no address is configured, the IP address of the egress interface on which the NAT
policy is applied will be used.
P
ARAMETERS
Parameter
1-65535
match
[{all|any}]
<match-list
name>
source-nat
static
D V
EFAULT ALUE
By default, NAT enables dynamic mapping.
E
XAMPLE
ALU(config-nat-N1)# match m1 source-nat static
576
Beta
The range for the NAT policy rule. This rule number signifies
the priority of a rule.
This command forms a match-list of the Common
Classifiers that are pre-configured. In this type of match, the
relevant action is performed even if one rule in the list is
satisfied.
Type of NAT, here it is the SNAT.
Use this keyword to use the static NAT.
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Description
Beta