Ppp Lcp Echo-Interval; Ppp Lcp Negotiate - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

-
PPP LCP ECHO INTERVAL
ppp lcp echo-interval <0-255>
D
ESCRIPTION
This command is used to set the interval between the LCP echo requests sent. "0"
implies that no echo requests are sent.
P
ARAMETERS
0-255
D V
EFAULT ALUE
The default value is 10 seconds.
E
XAMPLE
ALU(config-if Serial1/0:0)# ppp lcp echo-interval 200

PPP LCP NEGOTIATE

ppp lcp negotiate
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command is
used to initiate the LCP negotiation on the interface.
Note: LCP negotiation is automatically started when the encapsulation is set to PPP or when
the link is administratively brought up on a PPP interface, or when the MTU is
changed on the interface.
P
ARAMETERS
None.
E
XAMPLE
ALU(config-if Serial1/0:0)# ppp lcp negotiate
OmniAccess 700 CLI Command Reference Guide
Beta
Parameter
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
Denotes the interval between echo requests.

ppp lcp echo-interval

267
Beta