Framing; Interface Serial - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

FRAMING

framing {crc4|no-crc4}
D
ESCRIPTION
This command is entered in Configuration mode to configure framing to either
crc4 or no-crc4. The service provider determines which framing type, either crc4
or no-crc4 is required for your E1 circuit.
P
ARAMETERS
crc4
no-crc4
D V
EFAULT ALUE
The default framing value is crc4 in case of E1.
E
XAMPLE
ALU(config-controller E1)#framing no-crc4
ALU(config-controller E1)# no framing

INTERFACE SERIAL

interface Serial <slot/port:channel>
D
ESCRIPTION
This command is entered in the Configuration mode to configure a serial interface
in the specific slot or port of the E1 card.
P
ARAMETERS
slot/port:channel
E
XAMPLE
The following example enters into the interface configuration mode with a serial
interface having slot-number 0, port 0 with channel group 0.
ALU(config)#interface Serial 0/0:0
ALU(config-if serial0/0:0)#
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Parameter
Parameter
Alcatel-Lucent
Description
4-bit cyclic redundancy check i.e., CRC4
frame is the E1 frame type.
No cyclic redundancy check i.e.,CRC4
frame is not the E1 frame type.
Description
Specifies the slot number, port number
and the channel number.
Beta
framing
213