Ip Nat Statistics {In|Out|Both; No Debug Firewall Nat; No Ip Nat-Force - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Network Address Translation
IP NAT STATISTICS

ip nat statistics {in|out|both}

D
ESCRIPTION
This command is entered in the interface configuration mode. This command
turns on statistics for a given interface.
P
ARAMETERS
Parameter
in
out
both
D V
EFAULT ALUE
By default the NAT statistics on an interface is turned off.
E
XAMPLE
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)# ip nat statistics out
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)# no ip nat statistics out

NO DEBUG FIREWALL NAT

no debug firewall {session|filter|nat|attack|alg|intrusion|
selector [saddr <ip-address>|daddr <ip-address>|protocol
<number>|sport <number>|dport <number>][output|permanent]| all
[detail-level]}
This command turns off the debugging functionality which is enabled using the above
command.
-
NO IP NAT FORCE
no ip nat <policy-name> force
The "force" keyword will automatically detach the specified NAT policy from
respective interfaces, and deletes the policy. This command when used also
deletes all the associated NAT policy rules.
584
Beta
{ | | }
IN OUT BOTH
"in" means ingress traffic.
"out" denotes that egress traffic.
Implies both ingress and egress traffic
Alcatel-Lucent
Description
OmniAccess 700 CLI Command Reference Guide
Beta