Left running head:
Chapter name (automatic)
Point-to-Point Protocol over Ethernet (PPPoE)
ENCAPSULATION PPPOE
encapsulation pppoe
D
ESCRIPTION
Enter this command in the Interface Configuration Mode. This command sets the
PPPoE encapsulation on the Gigabit Ethernet interface. OA-700 always acts as a
PPPoE client.
P
ARAMETERS
None.
D
V
EFAULT
ALUE
None.
P
S
LATFORMS
UPPORTED
OmniAccess 740, 780
E
XAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# encapsulation pppoe
R
H
ELEASE
ISTORY
Release 2.3: command was introduced.
NO ENCAPSULATION PPPOE
no encapsulation pppoe
This command removes the PPPoE encapsulation configured on the interface.
This also removes the PPPoE server given IP address, and restores the
configured IP address on the interface (if any).
-
NO PPPOE MAX
no pppoe max-retry
The "no" command sets the max-retry value to its default, i.e., 0.
NO PPPOE RETRY
no pppoe retry-timer
The 'no' command resets the retry-timer to its default, i.e., 10 seconds.
NO PPPOE SERVICE
no pppoe service-name
This command removes the service name configured.
282
Beta
RETRY
-
TIMER
-
NAME
Alcatel-Lucent
OmniAccess 700 CLI Command Reference Guide
Beta