No Port Monitor Interface Switchport; Port Monitor Interface Switchport - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Port Monitoring

NO PORT MONITOR INTERFACE SWITCHPORT

no port monitor interface switchport <slot/port>
[{both|egress|ingress}]
This command is used to disable port monitoring. Specify the slot/port on which
traffic is not to be monitored.

PORT MONITOR INTERFACE SWITCHPORT

port monitor interface switchport <slot/port>
[{both|egress|ingress}]
D
ESCRIPTION
This command is entered in the Interface Configuration mode. This command is
used to configure port monitoring. Specify the traffic to be monitored.
P
ARAMETERS
both
egress
ingress
D V
EFAULT ALUE
By default, the both (egress and ingress) traffic is monitored.
E
XAMPLE
The following example shows that the switchports 1/6 and 1/7 are to be
monitored. Switchport 1/0 being the destination port, i.e, port receives the
mirrored data from switchports 1/6 and 1/7.
ALU(config-if switchport1/0)# port monitor switchport 1/6
both
ALU(config-if switchport1/0)# port monitor switchport 1/7
ingress
202
Beta
Parameter
Alcatel-Lucent
Description
Monitor both ingress and egress traffic.
Monitor egress traffic.
Monitor ingress traffic.
OmniAccess 700 CLI Command Reference Guide
Beta