Vrrp Group-Id Ip Ip-Address Secondary; Vrrp Group-Id Preempt - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Virtual Router Redundancy Protocol
-
VRRP GROUP ID
vrrp <1-8> ip <ip-address> secondary
D
ESCRIPTION
This command is used to configure the secondary IP address for a VRRP group
on an interface.
Note: The maximum number of secondary IP addresses allowed per VRRP group is 8.
P
ARAMETERS
Parameter
1-8
ip-address
secondary
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# vrrp 7 ip 10.91.0.101
secondary
-
VRRP GROUP ID PREEMPT
vrrp <1-8> preempt
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command
enables the preempt mode. By enabling the preempt mode, the configured router
takes over as the master of a group if it has a higher priority than the existing
master virtual router.
P
ARAMETERS
1-8
D V
EFAULT ALUE
Pre-emption is enabled by default.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# vrrp 7 preempt
144
Beta
-
IP ADDRESS SECONDARY
IP
Specifies the group number. It is in the range 1 - 8.
The secondary IP address of the VRRP group.
Use this keyword to set the IP address as the
secondary IP address for the VRRP group.
Parameter
Specifies the group number. It is in the range 1 - 8.
Alcatel-Lucent
Description
Description
OmniAccess 700 CLI Command Reference Guide
Beta