Framing; Interface Serial - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
T1E1 Line Card

FRAMING

framing {esf|sf}
D
ESCRIPTION
This command is used in the Controller Configuration mode. This command is
used to configure framing type. The service provider determines which framing
type, either sf or esf is required for your T1 circuit.
P
ARAMETERS
esf
sf
D V
EFAULT ALUE
The default framing on T1 line is esf.
E
XAMPLE
ALU(config-controller T1)#framing sf

INTERFACE SERIAL

interface serial <slot/port:channel>
D
ESCRIPTION
This command is entered in the Interface Configuration mode to configure a serial
interface.
P
ARAMETERS
slot
port
channel
E
XAMPLE
The following example creates an interface at slot 0 and port 0 at channel group 0:
ALU(config)#interface Serial0/0:0
ALU(config-if Serial0/0:0)#
228
Beta
Parameter
Parameter
Alcatel-Lucent
Description
Extended super frame is the T1 frame type.
Super frame is the T1 frame type.
Description
Specifies the slot location.
Specifies the port number.
Specifies the channel number.
OmniAccess 700 CLI Command Reference Guide
Beta