Debug Firewall Nat; Ip Nat - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Network Address Translation

DEBUG FIREWALL NAT

debug firewall
{session|filter|nat|attack|alg|intrusion|selector [saddr <ip-
address>|daddr <ip-address>|protocol <number>|sport <number> |
dport <number>][output|permanent]|all [detail-level]}
D
ESCRIPTION
This command turns on the debugging functionality for NAT on the OA-700.
P
ARAMETERS
saddr <ip-address>
daddr <ip-address>
protocol <number>
sport <number>
dport <number>
output
permanent
E
XAMPLE
ALU# debug firewall nat

IP NAT

ip nat <nat policy-name>
D
ESCRIPTION
This command is used to configure a NAT policy. This command enters the NAT
configuration mode.
P
ARAMETERS
Parameter
nat policy-name
E
XAMPLE
ALU(config)# ip nat N1
ALU(config-nat-N1)#
582
Beta
Parameter
Name of the NAT policy.
Alcatel-Lucent
Description
Source address.
Destination address.
Protocol.
Source port number.
Destination port number.
Specify output.
Allow debug flag(s) to be written with
configuration.
Description
OmniAccess 700 CLI Command Reference Guide
Beta