Destination Nat (Dnat) Configuration Commands; Destination-Nat - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

D NAT (DNAT) C
ESTINATION
-
DESTINATION NAT
[<1-65535>] match [{all|any}] <match-list name> destination-nat
{host {<ip-address|host-name>} [port <1-65535>]|pool <list-
name> [port <1-65535>|static]}
D
ESCRIPTION
Enter this command in the NAT configuration mode. This command is used to
configure a DNAT with one or more rules (associate match-lists and set priority for
the rule) for the configured DNAT.
And, this command is used to configure a DNAT with host IP address or an IP
address pool.
P
ARAMETERS
Note: Presently, 'Hostname' option is not supported. Only host IP address can be
configured.
Parameter
1-65535
match
[{all|any}]
<match-list
name>

destination-nat

ip-address
host-name
list-name
port <1-65535>
D V
EFAULT ALUE
None.
E
XAMPLE
ALU(config-nat-N2)# match m1 destination-nat host 192.168.10.91
ALU(config-nat-N2)# match m1 destination-nat pool l1
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)

Destination NAT (DNAT) Configuration Commands

ONFIGURATION
The range for the NAT policy rule. This rule number signifies
the priority of a rule.
This command forms a match-list of the Common
Classifiers that are pre-configured. In this type of match, the
relevant action is performed even if one rule in the list is
satisfied.
Type of NAT, here it is the DNAT.
The IP address of the host.
The host name.
The name of the list.
The port number for DNAT.
Alcatel-Lucent
C
OMMANDS
Description
Beta
577