Spanning-Tree Vlan Cost; Spanning-Tree Vlan Fwd-Time/Hello-Time/Max-Age/Priority - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Per VLAN Spanning Tree +
-
SPANNING TREE VLAN COST
spanning-tree [vlan <1-4094>] cost <1-65535>
D
ESCRIPTION
This command is entered in the Interface Configuration mode. This command
calculates the path cost of PVST+ on an interface.
This is configurable on a per port basis. It is used on LAN ports configured as
Layer 2 access ports.When two bridges compete for position as the root bridge,
the above command is used to prioritize an interface.
P
ARAMETERS
1-65535
D V
EFAULT ALUE
Default value: 4
E
XAMPLE
ALU(config-if switchport1/0)# spanning-tree vlan 100 cost 1000
-
SPANNING TREE VLAN FWD
spanning-tree [vlan <1-4094>] {forward-time <4-30>|hello-time
<1- 10>|max-age <6-40>|priority <0-65535>}
D
ESCRIPTION
This command is entered in the Configuration mode to configure a PVST+
Forward-time/Hello-time/Maximum-age/Bridge priority.
Note: If you do not enter a VLAN- ID, by default, it is taken as VLAN-1.
The ranges are as follows:
•
Forward time : 4 to 30 seconds
•
Hello time
•
Maximum age: 6 to 40 seconds
•
Bridge Priority : 0 to 65535
180
Beta
Parameter
- /
TIME HELLO
: 1 to 10 seconds
Alcatel-Lucent
Description
PVST+ port cost.
- / -
TIME MAX AGE
OmniAccess 700 CLI Command Reference Guide
Beta
/
PRIORITY