Pppoe Max-Retry - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

-
PPPOE MAX RETRY
pppoe max-retry <0-255>
D
ESCRIPTION
This command is entered in the interface configuration mode. This command sets
an upper limit on the number of unanswered PADIs sent by the PPPoE client
before the session attempt is given up.
If the max-retry value is set to 0, it keeps sending PADIs till it receives a PADO.
P
ARAMETERS
0-255
D V
EFAULT ALUE
The default max-retry value is 0.
P S
LATFORMS UPPORTED
OmniAccess 740, 780
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# pppoe max-retry 10
Note: max-retry value for PADR is not user configurable. Default max-retry value for PADR
is set to 5. After the fifth unanswered PADR, client starts sending PADI again.
R H
ELEASE ISTORY
Release 2.3: command was introduced.
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Parameter
Alcatel-Lucent
Description
Denotes the number of unanswered
PADIs sent by the PPPoE client before
the session attempt is given up.
Beta

pppoe max-retry

283