Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual page 570

To Configure a Rule Inside an IP Policy:
[<1-65535>] match [{all|any}] <match-list name>...[not
<match-list name>] {for-us|interface <interface-name> [next-
hop <ip-address>]|next-hop <ip-address>}
This command is entered in the PBR Configuration mode. This command is used
to configure rules (associate match-lists and set priority for the rule) for an IP
policy.
1-65535
match [{all|any}] <match-list
name>...
not <match-list name>]
for-us
interface <interface-name>
[next-hop <ip-address>]
next-hop <ip-address>
Example
ALU(config-ip-policy-pbr1)# 10 match m1 m2 not m3 interface
GigabitEthernet 3/0 next hop 1.2.2.1
ALU(config-ip-policy-pbr1)# 20 match m1 m2 next hop 1.2.2.2
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Parameter
Alcatel-Lucent
Description
Denotes the routing policy rule number.
The range for the IP policy rule.
This command forms a match-list of the
Common classifiers that are pre-
configured. In this type of match, the
relevant action is performed even if one
rule in the list is satisfied.
Specifies match-list with not option.
This keyword redirects the packet to the
management plane of the OA-700.
Specifies the egress path of the packet.
If the interface and next-hop are
specified together, then the packet shall
be forwarded to the specified next-hop
on the specified interface.
Specifies the egress path of the packet.
Beta
ip-policy
537