Ppp Timeout Max-Failure; Ppp Timeout Max-Terminate - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

Left running head:
Chapter name (automatic)
Point to Point Protocol
PPP TIMEOUT MAX
ppp timeout max-failure <1-30>
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command sets
the maximum number of configure NaK packets (LCP or NCP) sent without
sending a Configure Ack before assuming that configuration is not converging.
P
ARAMETERS
1-30
D V
EFAULT ALUE
The default max-failure value is "5 seconds".
E
XAMPLE
ALU(config-if Serial0/0:0)#ppp timeout max-failure 10
PPP TIMEOUT MAX
ppp timeout max-terminate <1-30>
D
ESCRIPTION
This command sets the maximum number of terminate request packets (LCP or
NCP) sent without receiving a Terminate Ack, before assuming that the peer is
unable to respond.
P
ARAMETERS
1-30
D V
EFAULT ALUE
The default max-terminate value is 2 seconds.
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp timeout max-terminate 10
270
Beta
-
FAILURE
Parameter
-
TERMINATE
Parameter
Alcatel-Lucent
Description
Maximum number of configure NaK packets
(LCP or NCP) to be sent without sending a
Configure Ack, before assuming that
configuration is not converging.
Description
The maximum number of terminate request
packets to be sent, before assuming that the
peer is unable to respond.
OmniAccess 700 CLI Command Reference Guide
Beta