Ip Ospf Authentication; Ip Ospf Authentication-Key - Alcatel-Lucent OmniAccess 700 CLI Command Reference Manual

IP OSPF AUTHENTICATION

ip ospf authentication [message-digest|null]
D
ESCRIPTION
This command is used in the Router Configuration mode. This command is used
to enable authentication for OSPF.
P
ARAMETERS
Parameter
message-digest
null
D V
EFAULT ALUE
The default authentication mode is Plain Text authentication.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf authentication
message-digest
IP OSPF AUTHENTICATION
ip ospf authentication-key {<0-0>|<password-key>}
D
ESCRIPTION
This command is used in the Interface Configuration mode. This command
assigns an authentication password to be used by OSPF routers on a network
segment.
P
ARAMETERS
Parameter
0-0 password key The OSPF password. Password need not be the same
D V
EFAULT ALUE
No password is specified.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip ospf authentication-
key passwordtest
OmniAccess 700 CLI Command Reference Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Specifies that message-digest authentication will be used.
No authentication is used. Overrides the authentication
configured for an area.
-
KEY
throughout the area but needs to be the same between
neighbors.
Alcatel-Lucent
ip ospf authentication
Description
Description
Beta
467