Table of Contents
Advertisement
Step 2: Configuring the OmniAccess AP or OmniAccess AP 1200R
Before Installation
The following procedures are designed to make sure that your OmniAccess AP physical installation goes
smoothly and that initial operation is as expected. If you are unable to prepare your OmniAccess AP for
deployment, this Step also describes RMA (Return Material Authorization) procedures.
Note:
Perform either of the following two procedures on each OmniAccess AP or OmniAccess
AP 1200R BEFORE deploying the OmniAccess AP or OmniAccess AP 1200R in its final location.
•
Preparing a Version 1.2 OmniAccess AP
Wireless System
•
Preparing a Version 2.0 OmniAccess AP or OmniAccess AP 1200R
Version 2.0 OmniAccess AP or OmniAccess AP 1200R
OmniAccess Wireless System
If you are unable to perform either of previous procedures, refer to the
Alcatel OmniAccess Wireless Product
Preparing a Version 1.2 OmniAccess AP
If your OmniAccess AP has Alcatel Wireless Operating System 1.2 or an earlier version loaded on it, or
if you do not know what version the AP has loaded on it, use this procedure. If your AP is a OmniAccess
AP 1200R or has Alcatel Wireless Operating System 2.0 or later loaded on it, use the
Version 2.0 OmniAccess AP or OmniAccess AP 1200R
Note:
This procedure assumes that you are preparing a version 1.2 OmniAccess AP to interop-
erate with a version 2.0 Alcatel OmniAccess Switch or Appliance. When you are preparing a
version 1.2 OmniAccess AP to interoperate with a version 1.2 Alcatel OmniAccess Switch or
Appliance, use the procedure found in the version 1.2 Alcatel OmniAccess Wireless Access
Point Quick Installation Guide.
Configuration Setup
Configuration Setup
Does My Configuration Qualify for this Procedure?
•
You must have a version 2.0 Alcatel OmniAccess Wireless Switch or Appliance on its own
subnet that can be reconfigured back and forth between Layer 2 and Layer 3 LWAPP operation.
If you do not have a spare or depot Alcatel OmniAccess Switch or Appliance that can be recon-
figured back and forth between Layer 2 and Layer 3 operation, refer to RMA Procedures later in
this document to RMA your version 1.2 OmniAccess APs.
3/16/04
Step 2: Configuring the OmniAccess AP or OmniAccess AP 1200R Before
Installation
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide
Step 2: Configuring the OmniAccess AP or OmniAccess AP 1200R Before Installation
for installation in a Version 2.0 Alcatel OmniAccess
Guide.
for installation in a Version 2.0 Alcatel
RMA Procedures
Preparing a Version 1.2 OmniAccess AP
procedure below.
Does My Configuration Qualify for this Procedure?
or
Alternate Preparing a
section in the
Preparing a
5
Advertisement
Table of Contents
