Port Channel Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
P C
ORT HANNEL
To create a virtual link aggregation interface and/or activate the Port Channel Interface Configuration
mode, enter the interface port-channel command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface port-channel 1
(config-p-chan1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
arp arpa on page 2439
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2440
lldp receive on page 2441
lldp send on page 2442
qos on page 2444
snmp trap on page 2445
snmp trap link-status on page 2446
spanning tree commands begin on page 2447
storm-control action shutdown on page 2453
storm-control on page 2454
switchport commands begin on page 2456
60000CRG0-35E
I C
NTERFACE OMMAND
Copyright © 2012 ADTRAN, Inc.

Port Channel Interface Command Set

S
ET
2438