ADTRAN AOS Version R10.1.0 Command Reference Manual page 2427

Command Reference Guide
ip rip send version
Use the ip rip send version command to configure the Routing Information Protocol (RIP) version the
unit sends in all RIP packets transmitted on the interface. Use the no form of this command to return to the
default setting. Variations of this command include:
ip rip send version 1
ip rip send version 2
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Command History
Release 1.1
Functional Notes
Use the ip rip send version to specify a RIP version that overrides the version (in the Router RIP)
configuration.
AOS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the loopback interface to transmit only RIP version 2 packets:
(config)#interface loopback 1
(config-loop 1)#ip rip send version 2
60000CRG0-35E
Transmits only RIP version 1 packets on the interface.
Transmits only RIP version 2 packets on the interface.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Loopback Interface Command Set
2427