ADTRAN AOS Version R10.1.0 Command Reference Manual page 2424

Command Reference Guide
ip policy route-map <name>
Use the ip policy route-map command to assign a policy route map to this interface. Use the no form of
this command to remove the route-map policy.
Syntax Description
<name>
Default Values
By default, no policy route map is assigned to this interface.
Command History
Release 11.1
Usage Examples
The following example assigns the policy route map policy1 to the interface:
(config)#interface loopback 1
(config-loop 1)#ip policy route-map policy1
60000CRG0-35E
Specifies the name of the policy route map to assign to this interface.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Loopback Interface Command Set
2424