Telnet6 - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

telnet6

Invokes a Telnetv6 session. A Telnetv6 session is used to connect to a remote system or device over an
IPv6 network.
telnet6 {ipv6_address | hostname} [if_name] [port port]
Syntax Definitions
ipv6_address
hostname
if_name
port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
To abort a Telnet session, enter CTRL + ] and then CTRL + D. Refer to your switch's User Manual
for more information on using Telnet.
•
If the session is invoked using the server's link-local address, the source interface name must be
provided.
•
Refer to the table on
Examples
-> telnet6 fe80::a00:20ff:fea8:8961 intf1
-> telnet6 ::1
-> telnet6 Sun.com
Release History
Release 6.3.1; command was introduced.
page 57-40
Specifies the IPv6 address for the Telnetv6 server.
Specifies the hostname for the Telnetv6 server.
The name of the interface used to reach the Telnetv6 server, if the target
has been specified using the link-local address.
The Telnet port on the destination device. Valid range is from 1024 to
65535.
page 57-1 for number of sessions supported.
Session Management Commands
OmniSwitch CLI Reference Guide June 2012