Telnet - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

telnet

Invokes a Telnet session. A Telnet session is used to connect to a remote system or device.
telnet {host_name | ip_address} [port port]
Syntax Definitions
host_name
ip_address
port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
To abort a Telnet session, enter CTRL + ] and then CTRL + D. Refer to your switch's User Manual
for more information on using Telnet.
•
Refer to the table on
Examples
-> telnet 172.17.6.228
Trying 172.17.6.228...
Connected to 172.17.6.228.
Escape character is '^]'.
Release History
Release 6.1; command was introduced.
page 57-38
Specifies the host name for the Telnet session.
Specifies the IP address for the Telnet session.
The Telnet port on the destination device. Valid range is from 1024 to
65535.
page 57-1 for number of sessions supported.
Session Management Commands
OmniSwitch CLI Reference Guide June 2012