show command-log
Displays the contents of the command.log file. This file contains a record of all CLI commands executed
on the switch since the command logging function was enabled. For more information on enabling and
disabling command logging, refer to
show command-log
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The show command-log command lists CLI commands in the descending order. In other words, the
most recent commands are listed first. In the example below, the command-log enable syntax is the
least recent command logged; the ip interface Marketing address 17.11.5.2 vlan 255 syntax is the
most recent.
•
By default, command logging is disabled. To enable command logging on the switch, use the
command-log
command.
•
As mentioned above, command history is archived to the command.log file. If this file is removed, the
command history will no longer be available. In addition, the command.log file has a 66,402 byte
capacity. This capacity allows up to 100 commands; if the maximum capacity is reached, only the 100
most recent commands display.
Examples
-> show command-log
Command : ip interface Marketing address 17.11.5.2 vlan 255
UserName : admin
Date
: FRI JAN 09 00:20:01
Ip Addr
: 128.251.19.240
Result
: SUCCESS
Command : ip interface "Distribution" 11.255.14.102 vlan 500 local-proxy-arp
UserName : admin
Date
: FRI JAN 09 00:19:44
Ip Addr
: 128.251.19.240
Result
: ERROR: Ip Address must not belong to IP VLAN 44 subnet
Command : command-log enable
UserName : admin
Date
: FRI JAN 09 00:18:49
Ip Addr
: 128.251.19.240
Result
: SUCCESS
OmniSwitch CLI Reference Guide
page
57-24.
June 2012
page 57-49