Ssh Enforce Pubkey-Auth - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ssh enforce pubkey-auth

Enables or disables Secure Shell public key and password authentication. When enabled, password authen-
tication is not allowed.
ssh enforce pubkey-auth {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Note that if a public key file (i.e., thomas_dsa.pub) exists in the flash/network/pub directory on the
switch, public key authentication is used even if this method of authentication is disabled using this
command. Rename, move, or delete the public key file to ensure that public key authentication is disabled.
Examples
-> ssh enforce pubkey-auth enable
Release History
Release 6.1.3; command was introduced.
Related Commands
telnet
sftp
MIB Objects
alaSshConfigGroup
alaSshPubKeyEnforceAdminStatus
page 57-46
Enforces only SSH public key authentication.
Enforces both SSH public key and password authentication.
default
disable
Invokes a Telnet session. A Telnet session is used to connect to a remote
system or device.
Starts an SFTP session. An SFTP session provides a secure file transfer
method.
Session Management Commands
OmniSwitch CLI Reference Guide June 2012