Ip Multicast Port Max-Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IP Multicast Switching Commands

ip multicast port max-group

Configures the maximum group limit learned per port. The limit is applicable on the given port for all
VLAN instances of the port.
ip multicast port slot | port max-group [num] [action {none | drop | replace}]
Syntax Definitions
slot | port
num
none
drop
replace
Defaults
By default, the max-group limit is set to zero.
parameter
Action
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Configuring a max-group value will have no affect on existing group memberships until the member-
ships are refreshed on the port/VLAN instance
•
The configuration is allowed even when the ip multicast status is disabled.
•
If the num and action parameters are not specified, then the limit is removed.
•
The max-group configuration on a port will override the VLAN or global configuration.
•
IGMP zapping must be enabled when the max-group limit is enabled and the action is dropped.
Examples
-> ip multicast port 1/1 max-group 10 action drop
-> ip multicast port 6/14 max-group 20 action replace
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
The maximum IGMP group count. Valid range is 0 to 4294967295.
Disables the maximum group limit configuration.
Drops the incoming membership request.
Replaces an existing membership with the incoming membership
request.
defaults
none
March 2011
ip multicast port max-group
page 21-13