Checking Existence Of Pvcs When Determining The Protocol State Of An Atm P2P Subinterface; Configuring A Pvc And The Maximum Number Of Pvcs Allowed On An Interface; Configuring Pvc Parameters - H3C SR6600 Configuration Manual

To do...
Set the MTU for the ATM
subinterface
Shut down the ATM interface
The keywords p2mp and p2p are available with the interface atm interface-number.subnumber only
when you are creating an ATM subinterface. If you are entering an existing ATM subinterface, the two
keywords are not available.
Checking Existence of PVCs When Determining the Protocol State of an ATM P2P
Subinterface
Follow these steps to check existence of PVCs when determining the protocol state of an ATM P2P
subinterface:
To do...
Enter system view
Create an ATM subinterface and
enter its view
Check existence of PVCs when
determining the protocol state of
the ATM P2P subinterface
Configuring a PVC and the Maximum Number of PVCs Allowed on
an Interface

Configuring PVC Parameters

Follow these steps to configure PVC parameters:
Enter system view
Enter ATM interface view or ATM
subinterface view
Create a PVC and enter PVC view
mtu mtu-number
shutdown
system-view
interface atm
interface-number.subnumber p2p
atm-link check
To do...
Use the command...
Use the command...
Use the command...
system-view
interface atm
{ interface-number |
interface-number.subnumber }
pvc { pvc-name [ vpi/vci ] |
vpi/vci }
1-7
Remarks
Optional
1500 bytes by default
Optional
By default, an ATM interface is up.
Remarks
—
Required
By default, the subinterface is
configured as point-to-multipoint
(p2mp).
Required
By default, the protocol state of the
ATM P2P subinterface is
consistent with the state of the
physical interface.
Remarks
—
—
Required
By default, no PVC is created.