Table of Contents
Advertisement
TX150 e-Manual D07-00-023 Rev A02
Page 6 of 107
technical resources, visit VeEX Inc web site at
www.veexinc.com
.
If you need assistance or have questions related to the use of this product, call or email our customer care department for
customer support. Before contacting our customer care department, you must have your serial number ready. Please go to
Basic
Operations
section for details on locating your unit serial number.
Customer Care:
Phone: + 1 408 970 9090
Email:
customercare@veexinc.com
Website:
www.veexinc.com
Go back to top
3.0 Safety Information
Safety precautions should be observed during all phases of operation of this instrument. The instrument has been designed to
ensure safe operation however please observe all safety markings and instructions. Do not operate the instrument in the
presence of flammable gases or fumes or any other combustible environment. VeEX Inc. assumes no liability for the customer's
failure to comply with safety precautions and requirements.
Optical Connectors
The TX150 displays a laser warning icon when the laser source is active to alert the user about a potentially dangerous situation.
It is recommended to;
1. Deactivate the laser before connecting or disconnecting optical cables or patchcords
2. Never to stare into an optical patchcord or the SFP's connector interface while the laser is enabled. Even though SFP optical
transceivers are typically fitted with Class 1 lasers, which are considered eye safe, optical radiation for an extended period can
cause irreparable damage to the eyes.
3. Never use a fiber microscope to check the optical connectors when the laser source is active
Electrical Connectors
Telephone lines may carry dangerous voltages. Always connect the electrical test ports to known test interfaces which carry low
level signals
Go back to top
4.0 Basic Operations
The unit is powered on and off from the red key on the keyboard area. In order to turn off the unit, press the Power key for at
least 2 seconds. If the unit is not responding, holding the Power key down by more than 10 seconds will force the unit to power
down.
Go back to top
4.1 Keypad
Advertisement
Table of Contents
