Advertisement
Fit the exhaust extensions (D) correctly onto the
centre silencer (C), matching up the welds
indicated and aligning at the rear with the
silencers.
Tighten the Torx clamps (4) fastening the centre
silencer (C) to the exhaust extensions (D).
Tightening torque
Torx clamp
Fasten the front heat shields (65) and (66), by
tightening the six screws indicated.
Tightening torque
Screw
ONLY for vehicles WITHOUT single oil heat
exchanger
Connect the gear oil pipe unions. Follow the
instructions given below to ensure proper
connection:
ensure that the notch on the safety ring nut (14)
is aligned with the pin (13);
connect the male union and turn the safety ring
nut (14) so that it is no longer aligned with the
pin (13);
ALWAYS ensure that the pipe union is effectively
connected.
Nm
Class
54.2 Nm
B
Nm
Class
8 Nm
B
Advertisement
