Advertisement
Fill the engine lubrication system (
Refit the central flat undertray section (
Filling the engine lubrication system (Applicable UP TO Engine No.153878)
Tightening torque
Oil draining cap
To prevent any oil from the cartridge-pump
For replacement, undo the three screws (2) and
Check that the gaiter is correctly coupled with
Tightening torque
Screw
Before refitting the new filter, clean the mating
Use filter cartridges recommended by Ferrari
Lubricate the rubber seal of the filter cartridge
Fit the new oil filter cartridge, (A) rotating it
Tightening torque
Oil filter cartridge
A3.01).
E3.12).
Magnetic cap M22x1.5
coupling leaking onto the heated components
of the exhaust system, there is a gaiter (1)
which can contain any leaks and channel
them downwards.
remove. Fit the new gaiter (1), installing in the
relative seat with the drain hole facing
downwards, and fasten by tightening the
three screws (2).
the lower crankcase shell.
surface on the lower crankcase shell.
only and check that the rubber seal of the
filter cartridge fits perfectly into the seat, with
the round part visible, and that there are no
cuts and/or cracks.
with a film of engine oil.
clockwise using the tool (95971560) and the
torque wrench (USAG D156).
60 Nm
Nm
Class
10 Nm
B
Nm
Class
30 Nm
B
Nm
Class
B
Advertisement
