Advertisement
Lift the vehicle with a vehicle lift so that the wheels are not in contact with the ground.
Start the engine and run at idle speed for 1 minute.
DO NOT apply any more turning force to the steering wheel once full lock is reached.
Check the power steering system fluid level (
Simultaneously, steer fully 10 times.
Lower the vehicle to bring the wheels into contact with the ground.
Wait for the engine coolant temperature to reach 90°C.
DO NOT apply any more turning force to the steering wheel once full lock is reached.
Check the power steering system fluid level (
Simultaneously, steer fully 10 times.
Repeat this procedure another three times.
Check the power steering system fluid level (
Refit the central flat undertray section (
DO NOT apply any more turning force to the
steering wheel once full lock is reached.
Fill the power steering fluid reservoir to the MAX
limit on the cap dipstick (A) while
simultaneously steering fully to the right and
left repeatedly until the power steering fluid
level stabilises and the fluid contains no
bubbles.
There are MIN and MAX levels indicated on
both sides of the dipstick. Use the levels on
the side indicating the temperature 20°C.
Start and stop the engine twice repeatedly.
Check that the fluid level is stable and that the
fluid is not emulsified with air.
If the power steering fluid level drops, top the
power steering fluid reservoir up to the MAX
limit on the cap dipstick (A) while
simultaneously steering fully to the right and
left repeatedly until the power steering fluid
level stabilises and the fluid contains no
bubbles.
There are MIN and MAX levels indicated on
both sides of the dipstick. Use the levels on
the side indicating the temperature 20°C.
A3.06).
A3.06).
A3.06).
E3.12).
Advertisement
