Advertisement
Refitting the electrohydraulic ABS/ASR unit
Open the pipe clamp indicated and release the
pipes from the relative clips.
Hydraulic brake fluid is corrosive.
Contact with brake fluid may cause severe
injury or damage to painted parts of the
vehicle.
In the event of skin contact with fluid, wash
the respective part of the body
immediately with plenty of water.
In the event of contact between the fluid and
painted parts of the vehicle, wash and dry
the respective areas immediately.
Undo the unions (1) leading from the master
brake cylinder and the calliper delivery unions
(2), and plug immediately to prevent brake
fluid spillage.
Lift the brake fluid pipes as much as possible,
taking care not to bend or twist the pipes.
Clean any spilt fluid immediately.
Disconnect the connector (3), lifting the safety
clip (4).
Undo screw (5), from above, and screws (6),
from below, fastening the electrohydraulic
ABS/ASR unit (A) to the relative mounting
bracket.
To illustrate the operation more clearly, the
photo shown here was taken from the front
left hand wheel bay, with the wheelhouse
cover removed.
Move the electrohydraulic unit laterally towards
the compartment revealed by the removal of
the battery, and remove from the engine
compartment.
Advertisement
