Advertisement
Check that the one or two machined conical
recesses on the gearbox flange are
approximately 180° from the white dot on the
rear of the transmission shaft.
If there are two machined conical recesses on
the gearbox flange, use the centre point
between the two recesses as a reference
point.
If there are no conical machined recesses, the
gearbox is perfectly balanced and no
referencing relevant to the transmission
shaft is necessary.
Fit the three shims (48) then snug and
subsequently fully tighten the six screws (47)
fastening the transmission shaft (49) to the
gearbox (50).
Proceed in a crossed pattern when both
snugging and tightening the screws to
torque.
Tighten the screws to the definitive torque with
a control angle of 90°.
Tightening torque
Screw with control angle of 90°
Fit the heat shield (Y) in the relative seat and
fasten by hand tightening the screws
indicated.
Nm
Class
60 Nm
A
Advertisement
