Advertisement
Repeat the same lock-release procedure for the disc on the opposite rear wheel.
Connect the battery (
Turn the ignition switch to II (Key-ON).
Connect the DEIS tester to the diagnostic socket (
F2.01).
Rotate the rear CCM brake disc to align one of the two holes (A) with
the toothed ring (B) for adjusting the Bowden cable.
Insert a suitably sized screwdriver (C) through the hole in the rear disc.
Using the screwdriver, turned the toothed ring anticlockwise (D) to
tighten the parking brake shows on the inner part of the disc and
lock the disc.
The disc must not turn when forcefully attempting to rotate the disc
manually.
After locking the disc, release slightly by turning the toothed ring
clockwise (E) by four clicks.
If the calibration cycle does not complete successfully after performing
this procedure, repeat the procedure, but releasing the disc by only
three clicks.
F2.10).
Select the "NPB
Parking
Brake" node,
select the
cycles screen,
then select
the cycle "10
NPB
COMPLETE
CYCLE".
Advertisement
