Advertisement
C4.03
Transmission housing
Removing the transmission housing
UP TO Engine No. 167394, in the event of transmission housing replacement, follow the indications given in
Technical Information No. 1916 of May 2011.
Disconnect the battery (
Remove the transmission shaft (
Remove the catalytic converters (
Leaving the oxygen sensors fastened to the catalytic converters, disconnect the relative connectors
only.
F2.01).
C4.02).
B7.03).
Undo the screws (1) fastening the starter motor
to the transmission housing (A)
Take particular care not to bend the pipes
and/or strain the cables excessively when
tilting the engine assembly.
Install the tool
(AS
107566) on a hydraulic jack
and bring into contact with the oil sump.
Tighten the screw (10) of tool
the engine assembly and allow access to the
upper transmission housing fastener nuts.
(AS
107566) to tilt
Advertisement
