Advertisement
The brake pedal (A) is pivoted on the pedal
board mounting by a pin (B), fastened at each
end by the clips (C).
The brake servo linkage is connected to the
brake pedal via a snap fit coupling within the
retainers (E).
With the brake pedal (A) in the rest position, the
switch (F) is ON; pressing the brake pedal (A)
deactivates the switch and activates the stop
lights.
Adjust the pedal travel limit as follows.
Ensure that the adjuster dowel (G) is unscrewed
so that it does not touch the stop (H) on the
pedal board mounting.
Ensure that the end stop (H) is perfectly aligned
with the adjuster dowel (G), so that
depressing the pedal brings the dowel into
contact with the centre of the stop.
Depress the brake pedal completely and hold in
this position.
Fit the stop light switch (F) in the relative seat on
the mounting and turn to fasten.
Release the pedal so that it presses against the
switch finger (F).
Tighten the adjuster dowel (G), with a spacer (M)
measuring 0.5 mm between the dowel and
the end stop.
Ensuring that the feeler gauge can move freely
without straining, tighten the checknut (N)
while preventing the adjuster dowel from
turning.
Tightening torque
Nut
Nm
Class
12 Nm
B
Advertisement
