Advertisement
System activation
Remove the door panel (
DO NOT disconnect the door panel connectors.
E3.08).
Press the relative button to lower the power
window and allow access to the relative
fasteners.
Slightly loosen the two screws (2) fastening the
door window to the mounting brackets.
Manually correct the position of the door window.
Once adjustment is complete, tighten the two
screws (2).
Tightening torque
Screw
Apply four strips of white adhesive tape to the
door window in the points indicated in the
image aside.
With the door closed and the window raised
completely, mark the strips of adhesive tape
with a marker pen in all the positions
indicated in the image aside.
Open the door and check that the marking (5)
shows that the door window intrudes into the
windscreen pillar seal by 2 mm.
Check that the marking (3) and the marking (4)
show that the door window intrudes into the
Front Roof shell seal by 4 mm.
With the door open and the door window raised
completely, check the marking (12) to
determine by how much the window rises to
reach the Spider configuration relative to the
Coupé configuration.
Bear this parameter in mind when adjusting by
how much the window intrudes into the
Front Roof shell seal, as the adjacent
corners of the door window and the
quarterlight must be aligned when in Spider
configuration.
If the distances measured are not within the
specified range, adjust preload as follows.
If the gaps measured are not within the specified
range, adjust as follows.
Nm
Class
9.5 Nm
B
Advertisement
