Advertisement
CAUTION
Always ensure that the pins of the support trolley
are inserted correctly in the respective holes on
the removable subframe.
Using a suitable wrench, raise each alignment
pin (70) of the trolley
fully into the respective hole on the front
removable subframe.
Undo the front screws (71).
The screws are not all the same length. Note
the position of each screw before removing.
Undo the two rear screw pairs (72).
Undo the centre screws (73).
Undo the two central screw pairs (74).
Check that the front removable subframe will not
be hindered by pipes and/or cables during
lowering.
Slowly lower the trolley lift platform
with the relative lowering handle to bring the
front removable subframe into the correct
position for removing the engine.
FROM Assembly No. 103179 (consult the Spare
Parts Catalogue to identify vehicles not
affected by modification)
Undo the screws indicated.
The screws are not all the same length. Note
the position of each screw before removing.
Check that the front removable subframe will not
be hindered by pipes and/or cables during
lowering.
Slowly lower the trolley lift platform
with the relative lowering handle to bring the
front removable subframe into the correct
position for removing the engine.
(AS
107565), and insert
(AS
107565)
(AS
107565)
Advertisement
