Advertisement
B3.06
Fuel vapour separator
Replacing the fuel vapour separator
Tightening torque
Fastening fuel vapour separator
Located in the upper section of the rear right wheel bay, in front of the diagnostic pump.
Remove the rear wheelhouses (
Refit the rear wheelhouses (
Connect the DEIS tester to the diagnostic socket (
Perform the "Fuel tank tightness test" cycle.
Nut
E3.05).
E3.05).
Detach the two quick-coupling pipes (1), undo
the nut (2) and then remove the fuel vapour
separator (A) from the wheel bay.
A "double-lock" safety clip is fitted on the pipe
leading from the carbon filter.
To disconnect the "double-lock" quick connector,
using due caution and by pressing on both
sides, push the safety clip out of its seat until
you hear the "unclick".
The difference between the safety clip "clicked"
and "unclicked" position is only a few
millimetres.
Then press on both sides of the quick-coupling
and remove the pipe.
Fit the fuel vapour separator (A) into its seat and
fasten it by tightening the nut (2) then connect
the two quick-coupling pipes (1).
Tightening torque
Nut
A "double-lock" safety clip is fitted on the pipe
leading from the carbon filter.
After connecting the quick connector fuel pipe
correctly, with due caution and pressing on
both sides of the double-lock clip, push the
clip into its seat until it clicks audibly into
place and the pipe is secured correctly.
The difference between the safety
clip "unclicked" and "clicked" position is only
a few millimetres.
F2.10).
Nm
Class
9 Nm
B
Nm
Class
9 Nm
B
Advertisement
