Advertisement
Connect the pipe (25) onto the water radiator
and fasten with a new clamp.
Fit the rigid pipes (19) in their respective seats
on the power steering fluid radiator, after
replacing the relative seals.
Tighten the nuts (18) fastening the rigid pipes
(19 )to the power steering fluid radiator.
Tightening torque
Nut
Fasten the rigid power steering fluid pipes (19)
and hand tighten the screw (17) on the
retainer clamp.
Fit the A.C. pipes (21) in their respective seats
on the condenser, after replacing the relative
seals.
Fit the A.C. pipes (21) into the respective clamps
and fasten with the nut (22).
ONLY for vehicles WITHOUT single oil heat
exchanger. Tighten the unions (23) for the
clutch hydraulic system oil pipes on the
relative radiator, then apply and fasten the
relative clamps (24).
Tightening torque
Union
Nm
Class
9 Nm
B
Nm
Class
40 Nm
B
Advertisement
