Advertisement
UP TO Assembly No. 85744
Fit the gearbox lock releaser (83), complete with
Bowden cables, on the relevant gearbox lock
release pin.
Apply grease SEGO to the ends of the screw
threads (84).
Tighten the screws (84) fastening the gearbox
lock releaser (83).
Tightening torque
Screw
Fasten the Bowden cables (82) as originally
installed, by tightening the clamps/nuts
indicated.
Tightening torque
Nut
Fasten the Bowden cables (82) onto the
mounting bracket, fitting the Seeger rings
indicated (red arrows).
Lift the wheel module, fitting the axle shaft onto
the differential flange.
Support the weight of the rear suspension
adequately; fit the relevant pin complete with
washers and tighten the nut (81).
Fit the pin (80) with relevant washers and tighten
the nut (79) fastening the toe-in adjustment
tie-rod to the hub carrier.
Repeat the three previous operations for the
left hand rear suspension.
Nm
Class
30 Nm
B
Nm
Class
8 Nm
C
Advertisement
