Advertisement
Clean the windscreen mating surface thoroughly with compressed air, then degrease with heptane to
remove all traces of adhesive or dust.
Apply strips of adhesive tape to the bodywork,
around the perimeter of the windscreen seat.
Take care not to damage the bodywork;
Remove residual sealant with the (Excalibur
pneumatic cutter with ESM - 519 short blade)
(A).
If present, remove the sealant applied between
the external windscreen pillar trim panels and
the windscreen, then degrease with heptane
to remove all adhesive or dust residue.
If necessary, replace the two locator tabs (1),
refitting as originally installed using the
following procedure.
Advertisement
