Advertisement
Refit the luggage bench (
E4.01).
Prise out the cable grommet (1).
Prise out the plug (2).
Disconnect the connector (3).
Remove the fastener ring (4), undoing the
indicated screws.
Note the orientation of the fuel level sensor (A).
Remove the fuel level sensor (A) and replace.
ALWAYS replace the O-ring, cleaning the
respective seat thoroughly.
Orienting correctly, install the new fuel level
sensor (A).
Check that the mating surfaces of the fastener
ring (4) are clean.
Fit the fastener ring (4) and tighten the indicated
screws.
Tightening torque
Screw
Connect the connector (3).
Fit the cap (2).
Fit the cable grommet (1).
Nm
Class
5 Nm
B
Advertisement
