Advertisement
Refit the wheels (
Connect the battery (
Only in the case of replacing the pads. Bed-in the CCM brake pads (
Bedding-in CCM brake pads
The following procedure is applicable for both CCM1 and CCM2 brake systems and must be performed
EACH TIME the CCM brake pads and/or CCM brake discs are replaced.
For vehicles intended for ROAD use
Brake 16 times from 80 Km/h to 30 Km/h with constant pressure on the brake pedal and without
activating the ABS system.
Allow the brake system to cool by driving at 80 Km/h for approximately 120 seconds.
Brake 16 times from 120 Km/h to 30 Km/h with constant pressure on the brake pedal and without
activating the ABS system.
Allow the brake system to cool by driving at 80 Km/h for 180 seconds.
Allow the brake system to cool completely before using the vehicle again after the bedding-in
procedure to ensure maximum braking efficacy.
As soon as you notice an increase in brake pedal travel, stop the car and wait for the brake system to cool
completely.
For vehicles intended for TRACK use
Brake 9 times from 130 Km/h to 30 Km/h with constant pressure on the brake pedal and without
activating the ABS system.
Allow the brake system to cool by driving at 80 Km/h for approximately 240 seconds.
Brake 3 times from 200 Km/h to 30 Km/h with constant pressure on the brake pedal and without
activating the ABS system.
Allow the brake system to cool by driving at 80 Km/h for 300 seconds.
Allow the brake system to cool completely before using the vehicle again after the bedding-in
procedure to ensure maximum braking efficacy.
As soon as you notice an increase in brake pedal travel, stop the car and wait for the brake system to cool
completely.
D2.01).
F2.01).
Close the clamp (3) to fasten the pad wear
sensor cable.
Fit a new clamp (2).
Connect the connector (1) for the brake pad
wear sensor.
A3.19).
Advertisement
