Advertisement
C2.05
DCT gearbox water/gear oil/clutch hydraulic system oil single oil heat
Removing the water/gear oil/clutch hydraulic system oil single oil heat exchanger
CAUTION
ALWAYS PERFORM THE OPERATIONS WITH COLD ENGINE AND EXHAUSTS.
FROM Ass.ly No. 90609, a single oil heat exchanger solution has been introduced to cool both the gear
system oil and the hydraulic clutch system oil.
Remove the rear bumper (
exchanger (for vehicles WITH single oil heat exchanger)
E3.04).
Clean the coolant delivery pipe inlet area (1) with
a suitable degreaser that does not leave
residue.
Place a container under the indicated clamp.
Remove the coolant delivery pipe (1) from the
single oil heat exchanger (A) and loosen the
indicated clamp.
Pour the fluid drained from the system into a
container and seal it. DO NOT DISPOSE
OF USED FLUID IN THE
ENVIRONMENT.
Detach the coolant delivery pipe (1) and allow
the liquid in the pipe to drain.
Clean and dry any fluid residue.
Place suitable plugs on the inlets.
Advertisement
