Advertisement
ONLY for vehicles WITH single oil heat exchanger
Remove the water/gear oil/clutch hydraulic system oil single oil heat exchanger (
Remove the single oil heat exchanger mounting subframe (
ONLY for vehicles WITHOUT single oil heat
exchanger
Remove the clamps indicated retaining the GL
pipes (69).
Detach the GL pipes (69) from the gearbox,
removing the O-rings from the relevant unions.
Plug the oil inlet and outlet orifices immediately.
ONLY for vehicles WITHOUT single oil heat
exchanger
Clean the area surrounding the ATF pipe
fastening points thoroughly with a suitable
degreaser that does not leave residue.
Place absorbent paper under the unions to
collect any oil spillage.
Undo the screw (73) fastening the fork (74)
retaining the ATF pipes.
Remove the nut indicated on the clamp retaining
the ATF pipes (72).
Detach the ATF pipes (72) from the gearbox,
removing the O-rings from the relevant unions.
Plug the oil inlet and outlet orifices immediately.
C2.05).
ONLY for vehicles WITH single oil heat
exchanger
Clean the area surrounding the GL pipe
fastening points thoroughly with a suitable
degreaser that does not leave residue.
Undo the screw (70) and remove the fork (71).
Place absorbent paper under the unions to catch
any oil spillage.
Disconnect and remove the GL pipes (69) from
the gearbox.
Plug the oil inlet and outlet orifices immediately.
C2.05).
Advertisement
