Advertisement
Refit the rear flat undertray section (
Calibrate the EPB electric parking brake (
This procedure must only be performed if, at Key-ON, the NPB parking brake node identifies a fault, indicated on the
instrument panel and on the TFT display by the specific warning lamps, and with error C155A on the NPB (EPB
calibration error) and error C1313 on the NFR (parking brake error).
Removing the EPB electric parking brake shoes
The following procedure is for removing the rear right hand wheel brake shoes.
With the exception of the specific steps indicated, the procedure for removing the rear left hand wheel brake shoes is the same.
Only for vehicles with DCT gearbox. Disable the EPB electric parking brake Autohold function (
Only for vehicles with mechanical gearbox. Disengage the electric parking brake (EPB).
Remove the wheels (
Remove the rear ones.
Remove the brake discs (
Remove the rear ones.
Remove the rear flat undertray section (
E3.12).
D3.07).
D2.01).
D3.03).
E3.12).
Press on the two indicated fastener tabs and fit the right hand EPB
Bowden cable sheath (B) into the relative mounting bracket.
Attach the end (2) of the right hand EPB Bowden cable (B) onto the
EPB linkage bracket (A).
Refit the clip (1) onto the EPB linkage bracket.
Use a suitable screwdriver to prise the clip (1) off the EPB linkage
bracket.
Detach the end (2) of the right hand EPB Bowden cable (B) from the
EPB linkage bracket (A)
Press on the two indicated fastener tabs and remove the right hand
EPB Bowden cable sheath (B) from the relevant mounting bracket.
D3.07).
Advertisement
