Advertisement
Fit the shims (16) in the relative seats, pushing
down completely onto the threaded rods and
ensuring that they are perfectly perpendicular
to the horizontal axis of the Flanblocs.
UP TO Assembly No. 98014, fork type spacers
(16) are used.
FROM Assembly No. 98015, plate type spacers
(16) are used.
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm
fastener nuts, complete with relative
washers, each time they are removed.
Replacement is NOT necessary if the nuts
are loosened only.
Tighten the indicated nuts fastening the lower
arm (F) to the chassis in the following order:
(a), (b), (c), (d).
Tightening torque
Nut (pretightening)
Nut
Attach the tie-rod (15) for the NRRPS motion
sensor onto the lower arm (F).
Magnetorheological shock absorbers (optional)
only.
Check that the yellow reference markings are
correctly aligned: the markings on the
threaded rods and the markings on the
Flanbloc eyebolts must be aligned.
Nm
Class
25 Nm
A
60 Nm
A
Advertisement
